The HALOTRONIC HTi is a DALI transformer for use with low voltage halogen lamps, and is suitable where you need dimming below 1 %. Highly energy-efficient, it provides short-circuit, overtemperature and overload protection (electronically reversible) and electrical isolation between the primary and secondary sides. It does not allow switching between the electronic transformer and the lamp. HALOTRONIC HTi is suitable for use inside; for effect and accent lighting, object lighting, recessed and surface-mounted ceiling light fittings and for the illumination of spaces such as conference rooms and living rooms. It is also good for shoplighting and restaurant lighting. It consumes little power, yet has a large temperature range, and its protective operation throughout the entire partial-load range promotes lamp life. You can through-wire HALOTRONIC HTi on the primary side.

HALOTRONIC HTi

thumbnail

HTI DALI 105/230…240 DIM

Product benefits
  • Very low power consumption thanks to high efficiency
  • Through-wiring possible on the primary side
  • Large temperature range
  • Protective operation throughout the entire partial-load range for long lamp life
Areas of application
  • Effect and accent lighting
  • Living rooms
  • Object lighting
  • Conference rooms
  • Restaurants
  • Recessed and surface-mounted ceiling luminaires
  • Shop lighting
  • Event rooms
  • Suitable for indoor installations
Product features
  • DALI transformer for low voltage halogen lamps
  • Electrical isolation between the primary side and the secondary side
  • Short-circuit protection, overload protection, overtemperature protection: electronically reversible
  • Switching between electronic transformer and lamp not permitted
  • Energy efficiency: ≥ 91 % (according to ErP regulation 2012/1194/EC)
  • Device fits also for special applications where dimming below 1 % is required
Family datasheet

Electrical data

Lamp wattage 35…105 W
Line current 0.45 A
Input voltage DC 176…275 V
Nominal voltage 230…240 V
Power factor λ 0.95

Minimum

Operating frequency 40 kHz

Approximately

Nominal output voltage 11.6 V

105 W / 35 W

Nominal output voltage 11.4 V

105 W / 35 W

Mains frequency 50…60 Hz
System wattage 108.00 W
Max. ECG no. on circuit breaker 10 A (B) 23
Max. ECG no. on circuit breaker 16 A (B) 38
Galvanic isolation primary/secondary 4.00 kV
Inrush current 0.6 A

Dimensions & weight

Length 170.0 mm
Width 44.0 mm
Height 34.0 mm
Wire preparation length, input side 8.0 mm
Wire preparation length, output side 8.0 mm
Mounting hole spacing, length 140.0 mm
Product weight 160.00 g

Temperatures & operating conditions

Ambient temperature range -20…+50 °C
Maximum temperature at tc test point 75 °C

Additional product data

Design / version Long with cable clamp

Capabilities

Dimming method DALI or Touch DIM/Touch DIM Sensor
Dimming interface DALI
Dimming interface Touch DIM
Overload protection Automatic reversible
Overheating protection Automatic reversible
Short-circuit protection Automatic reversible
Max. cable length to lamp/LED module 2.0 m
Cable/wire types, input side H03VV-F 2x0.50 mm²
Cable/wire types, input side H03VV-F 2x0.75 mm²
Cable/wire types, input side H03VVH2-F 2x0.75 mm²
Cable/wire types, input side H05VVH2-F 2x0.75 mm²
Cable/wire types, input side H05VV-F 2x2.5 mm²
Cable/wire types, input side H05VV5G 1.5 mm²
Cable/wire types, input side NYM-O 2x1.5 mm²
Cable/wire types, input side NYM-J 3x1.5 mm²
Cable/wire types, input side NYM-J 5x1.5 mm²
Cable/wire types, output side H03VV-F 2x0.75 mm²
Cable/wire types, output side H05VV-F 2x0.75 mm²
Cable/wire types, output side H05VV-F 2x1.5 mm²
Cable/wire types, output side H05VV-F 2x2.5 mm²
Cable/wire types, output side NYM-J 3x1.5 mm²
Cable/wire types, output side NYM-J 3x2.5 mm²
Cable/wire types, output side NYM-O 2x1.5 mm²
Dimmable Yes
Dimming range 0.1…100 %

With AC; 1…100% with DC

No-load proof Yes

Certificates & standards

Approval marks – approval E1 approval
Approval marks – approval VDE
Approval marks – approval VDE-EMC
Standards Acc. to EN 55015:2006 + A1:2007/Acc. to EN 61000-3-2/Acc. to EN 61547/Acc. to EN 61347-2-2
Type of protection IP20

EAN

Unit
Piece

Dimension

Weight

Volume

4008321420633 UNV
1
160.00g
4008321420640 VS
10
235mm x 89mm x 183mm 1711.00g 3.83dm³

EAN

METEL code

STK number

4008321420633 OSRHTIDALI105 4030093