OT 20/220 240/24 DIM P
Product family benefits
- Large range of products from 20 W to 250 W
- Installation in very cold and hot environments
- Very stable output power
- High electronical reversible short-circuit, overload, overtemperature protection
- Smart Power Supply: boosting power to turn on cold LEDs
- Independent installation possible
- Dimming range: 1 100 %
Areas of application
- Facades, public squares, cruise ships
- Signage
- Suitable for indoor and outdoor installations
Technical Data
Electrical data
Nominal input voltage
220 240 V
Mains frequency
0 60 Hz
Input voltage AC
198 264 V
Total harmonic distortion
< 15 %
Power factor λ
0.95
Efficiency in full-load
83 %
Device power loss
3.4 W
Inrush current
20 A
Max. ECG no. on circuit breaker 10 A (B)
49
Max. ECG no. on circuit breaker 16 A (B)
77
Max. ECG no. on circuit breaker 25 A (B)
120
Surge capability (L-N)
4 kV
Nominal output voltage
24.2 V
U-OUT (working voltage)
30 V
Nominal output power
20 W
Maximum output power
20 W
Galvanic isolation
SELV
Galvanic isolation primary/secondary
3 kV
Input voltage DC
176 276 V
Dimensions & weight
Mounting hole spacing, length
169.0 mm
Product weight
315.00 g
Cable cross-section, input side
1.0 mm²
Cable cross-section, output side
1.0 mm²
Wire preparation length, input side
90 mm
Wire preparation length, output side
90 mm
Cable/wire length, control input
320 mm
Cable/wire length, input side
300 mm
Cable/wire length, output side
300 mm
Length
178.0 mm
Height
25.0 mm
Width
43.0 mm
Colors & materials
Casing material
Plastic
Temperatures & operating conditions
Ambient temperature range
-30 +55 °C
Maximum temperature at tc test point
85 °C
Max.housing temperature in case of fault
110 °C
Temperature range at storage
-40 +85 °C
Permitted rel. humidity during operation
5 85 %
Lifespan
ECG lifetime
50000 h
Capabilities
Dimmable
Yes
Dimming interface
1 10 V
Dimming range
1 100 %
Dimming method
Pulse Width Modulation
Overheating protection
Yes
Overload protection
Yes
Short-circuit protection
Yes
No-load proof
Yes
Intended for no-load operation
No
Suitable for fixtures with prot. class
II
Type of connection, output side
Cables
Number of channels
1
Certificates & standards
Approval marks approval
ENEC / RCM / CCC / EAC
Standards
Acc. to EN 61347-1/Acc. to EN 61347-2-13/Acc. to EN 55015/Acc. to EN 61547/Acc. to EN 61000-3-2/Acc. to EN 61000-3-3/Acc. to EN 60598-1/Acc. to EN 62384
Protection class
II
Type of protection
IP66
Logistical data
Commodity code
850440839000
Environmental information
Information according Art. 33 of EU Regulation (EC) 1907/2006 (REACh)
Date of Declaration
11-10-2022
Primary Article Identifier
4052899545809
Candidate List Substance 1
Lead
CAS No. of substance 1
7439-92-1
Safe Use Instruction
The identification of the Candidate List substance is sufficient to allow safe use of the article.
Declaration No. in SCIP database
3ac33778-1523-4e42-9991-160545108a95
Packaging information
EAN |
Unit |
Piece |
Dimension l x w x h |
Weight |
Volume |
---|---|---|---|---|---|
4052899545809 |
FS
| 1 | |||
4052899545816 |
VS
| 20 | 334mm x 277mm x 186mm | 8116.00g | 17.21dm³ |
Downloads
Data sheets
Information about Family
Free yourself to design and install optimized, innovative, unique lighting design and luminaires, even in tight and flat light fittings or in sites such as suspended ceilings, with your choice of compact constant voltage supply from the OPTOTRONIC OT 80/220
240/24 DIM P range of CV Power supplies 24 V with 1
10 V. Dimmable via a fully isolated 1
10 V interface, they are suitable for use in SELV installations both inside and outside and have an output power range of up to 240 W.
Product family features
- DC mode functionality
- Type of protection: IP66 and IP67
- Surge protection: up to 4 kV (L-N) / 6 kV (L/N-PE)
- Wide operating temperature range: -30 +55 °C
- Lifetime: up to 50,000 h (temperature at max. tc )
- Dimmable via fully isolated 1 10 V interface
Ecodesign regulation information:
Intended for use with LED modules.
The forward voltage of the LED light source shall be within the defined operating window of the control gear in all operating conditions including dimming if applicable.
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.
Intended for use with LED modules.
The forward voltage of the LED light source shall be within the defined operating window of the control gear in all operating conditions including dimming if applicable.
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.
Products
Product |
|
|
|
|
|
Data sheet | ||
---|---|---|---|---|---|---|---|---|
![]() |
OT 20/220
240/24 DIM P
|
20 W | Yes | 178.0 mm | 43.0 mm | 25.0 mm | ||
![]() |
OT 40/220
240/24 DIM P
|
40 W | Yes | 208.0 mm | 43.0 mm | 26.0 mm | ||
![]() |
OT 60/220
240/24 DIM P
|
60 W | Yes | 208.0 mm | 43.0 mm | 26.0 mm | ||
![]() |
OT 100/220
240/24 DIM P
|
100 W | Yes | 240.0 mm | 50.0 mm | 34.0 mm | ||
![]() |
OT 130/220
240/24 DIM P
|
130 W | Yes | 220.0 mm | 63.0 mm | 37.0 mm | ||
![]() |
OT 250/220
240/24 DIM P
|
250 W | Yes | 265.0 mm | 68.0 mm | 40.0 mm |