OT FIT 150 /220-240/24 PC
Product family benefits
- IP rating: IP20
- High efficiency
- Very stable output power
- High electronical reversible short-circuit, overload, overtemperature protection
- Independent installation possible
Areas of application
- Suitable for luminaires of protection classes I and II
- Hospitality – decorative lighting, night light
- Restaurants – decorative lighting
- Shops – decorative lighting, shelf lighting
- Residential – cove lighting, under cabinet lighting
Technical Data
Electrical data
Nominal input voltage
220…240 V
Mains frequency
50/60 HZ Hz
Input voltage AC
198…264 V
Total harmonic distortion
< 15 %
Power factor λ
> 0.95
Efficiency in full-load
92 %
Device power loss
13 W
Inrush current
< 60 A
Max. ECG no. on circuit breaker 10 A (B)
2
Max. ECG no. on circuit breaker 10 A (C)
3
Max. ECG no. on circuit breaker 16 A (B)
4
Max. ECG no. on circuit breaker 16 A (C)
6
Surge capability (L/N-Ground)
2 kV
Surge capability (L-N)
1 kV
Nominal output voltage
24.2 V
Nominal output power
60.5...151.3 W
Maximum output power
151.3 W
Galvanic isolation
SELV
Output PWM frequency
3 k Hz
Dimensions & weight
Mounting hole spacing, length
159.5 mm
Product weight
580.00 g
Cable cross-section, input side
0.75…1.5 mm²
Cable cross-section, output side
0.75…1.5 mm²
Wire preparation length, input side
7…8 mm
Wire preparation length, output side
7…8 mm
Mounting hole spacing, width
66 mm
Width
76.0 mm
Length
170.0 mm
Height
30.0 mm
Colors & materials
Casing material
Plastic
Temperatures & operating conditions
Ambient temperature range
-20…+45 °C
Maximum temperature at tc test point
80 °C
Max.housing temperature in case of fault
110 °C
Temperature range at storage
-20…80 °C
Permitted rel. humidity during operation
5…85 %
Lifespan
ECG lifetime
50000 h
Capabilities
Dimmable
Yes
Dimming interface
Phase Cut
Dimming range
3…100 %
Dimming method
PWM
Overheating protection
Yes
Overload protection
Yes
Short-circuit protection
Yes
No-load proof
Yes
Suitable for fixtures with prot. class
I
Type of connection, input side
Fixed connection (terminal)
Type of connection, output side
Fixed connection (terminal)
Control interface
Trailing edge dimmer recommended
Number of channels
1
Programming
Tuner4TRONIC
No
Certificates & standards
Approval marks – approval
CE / ENEC / CCC / RCM / UKCA / EAC / SELV / CB
Standards
Acc. to EN 61347-1/Acc. to EN 61347-2-13/Acc. to EN 55015/Acc. to EN 61547/Acc. to EN 60598-1/Acc. to EN 62384/CISPR 15/EN 55015
Protection class
II
Type of protection
IP20
Logistical data
Commodity code
85044083900
Environmental information
Information according Art. 33 of EU Regulation (EC) 1907/2006 (REACh)
Date of Declaration
16-06-2023
Primary Article Identifier
4062172237642
Candidate List Substance 1
Lead
CAS No. of substance 1
7439-92-1
Safe Use Instruction
The identification of the Candidate List substance is sufficient to allow safe use of the article.
Declaration No. in SCIP database
c8d942cb-c0d0-46d9-8c20-823a1003a630
Packaging information
EAN |
Unit |
Piece |
Dimension l x w x h |
Weight |
Volume |
|---|---|---|---|---|---|
| 4062172237642 |
UNV
| 1 | 170mm x 76mm x 30mm | 580.00g | 0.39dm³ |
| 4062172237659 |
VS
| 10 | 400mm x 187mm x 99mm | 6142.00g | 7.41dm³ |
Downloads
Data sheets
Accessories optional
Information about Family
Product family features
- 24 V constant output voltage
- SELV
- Wide Ta range -20 – +50 ℃
- Lifetime 50 000 h at tc max
- Dimming range: 3…100 % luminous flux
- Recommended to Use Trailing Edge dimmer
Ecodesign regulation information:
Intended for use with LED modules.
The forward voltage of the LED light source shall be within the defined operating window of the control gear in all operating conditions including dimming if applicable.
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.
Intended for use with LED modules.
The forward voltage of the LED light source shall be within the defined operating window of the control gear in all operating conditions including dimming if applicable.
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.
Products
| Product |
|
|
|
|
|
Data sheet | ||
|---|---|---|---|---|---|---|---|---|
|
OT FIT 36 /220-240/24 PC
|
2.42…36.3 W | Yes | 103.0 mm | 67.0 mm | 29.5 mm | ||
|
OT FIT 75 /220-240/24 PC
|
24.2...75.8 W | Yes | 110.0 mm | 76.0 mm | 30.0 mm | ||
|
|
OT FIT 150 /220-240/24 PC
|
60.5...151.3 W | Yes | 170.0 mm | 76.0 mm | 30.0 mm |