OTi DALI 80/220…240/24 1…4 CH
- Intelligent power matching thanks to Smart power supply
- Slim form factor for mounting on the cove or in linear luminaires
- Reduced flicker thanks to high PWM frequency
- Suitable for installation in emergency lighting systems according to EN 60598-2-22
- Available as single-channel or multi-channel with DT6 and DT8 in one device
- DALI message detection "LED Module failure"
- IP rating: IP20
- Cove lighting, wall washer, corridor, handrail, luminous ceilings
- Suitable for use in luminaires of protection class I and II
- Suitable for 24 V LED modules
Technical Data
Electrical data
Nominal input voltage
220…240 V
Mains frequency
50/60 Hz
Input voltage AC
198…264 V
Total harmonic distortion
< 5 %
Power factor λ
> 0.95
ECG efficiency
93 %
Device power loss
6.2 W
Power loss in stand-by mode
0.3 W
Inrush current
48 A
Max. ECG no. on circuit breaker 10 A (B)
6
Max. ECG no. on circuit breaker 16 A (B)
10
Max. ECG no. on circuit breaker 25 A (B)
18
Surge capability (L/N-Ground)
2 kV
Surge capability (L-N)
1 kV
Nominal output voltage
24 V
U-OUT (working voltage)
24.2 V
Nominal output power
80 W
Galvanic isolation
SELV
Galvanic isolation primary/secondary
3.75 kV
Input voltage DC
176…276 V
Dimensions & weight
Mounting hole spacing, length
300.6 mm
Product weight
191.00 g
Cable cross-section, input side
0.5…2.5 mm²
Cable cross-section, output side
0.2…1.5 mm²
Wire preparation length, input side
6.0 mm
Wire preparation length, output side
5.0 mm
Length
346.0 mm
Height
22.0 mm
Width
32.0 mm
Colors & materials
Casing material
Plastic
Temperatures & operating conditions
Ambient temperature range
-20…+45 °C
Maximum temperature at tc test point
85 °C
Max.housing temperature in case of fault
115 °C
Temperature range at storage
-40…+85 °C
Permitted rel. humidity during operation
5…85 %
Lifespan
ECG lifetime
50000 h
Additional product data
Product remark
Emergency lighting: EL sign
Capabilities
Dimmable
Yes
Dimming interface
DALI-2
Dimming range
0…100 %
Dimming method
Pulse Width Modulation
Overheating protection
Automatic reversible
Overload protection
Automatic reversible
Short-circuit protection
Automatic reversible
No-load proof
Yes
Suitable for fixtures with prot. class
I / II
Type of connection, output side
Screw terminal
Number of channels
4
Certificates & standards
Approval marks – approval
CE / ENEC 10 / VDE / VDE-EMC / RCM / EAC / CCC / BIS / EL
Standards
Acc. to EN 61347-1/Acc. to EN 61347-2-13/Acc. to EN 61547/Acc. to EN 61000-3-2/Acc. to EN 62384/Acc. to EN 60598-2-22/Acc. to EN 62386/Acc. to EN 55015
Protection class
II
Type of protection
IP20
Logistical data
Commodity code
850440829000
Packaging information
EAN |
Unit |
Piece |
Dimension l x w x h |
Weight |
Volume |
|---|---|---|---|---|---|
| 4052899452893 |
UNV
| 1 | 346mm x 32mm x 22mm | 191.00g | 0.24dm³ |
| 4052899452909 |
VS
| 20 | 370mm x 170mm x 113mm | 3998.00g | 7.11dm³ |
Downloads
Data sheets, brochures and technical information
Modul-ECG Combination
LFP1200-G3
Information about Family
This module is suitable for emergency lighting systems and also available as a Tunable White version. The Output power can be shared arbitrarily among the 2 or 4 channels and a PWM frequency of 1KHz minimizes flickering.
- Dimmable via Touch DIM (if supported)
- LED driver whose output power can be shared arbitrarily among the 2 or 4 channels
- Dimming range: 0.1…100 %
- Line frequency: 0 Hz | 50 Hz | 60 Hz
Tender text
OSRAM OTi DALI 80/220-240/24 1-4 CH
Led Driver with DALI interface for independent mounting24V constant voltage power supply with multichannel output (4) to freely distribute the load 80W maxPolarity insensitive line voltage proof DALI control interface according EN 62386 DALI backchannel feedback for idle state, thermal shutdown, overload situation and lamp failure Complaint to EL (EN 50172) emergency lighting installationCompatible with Inotec or EATON systemOver load protection by self-dimming regulation Short circuit protection with automatic restartOver load protection with automatic restartOver temperature protection with automatic restartDimmable range 0…0,1% - 100% by PWM frequency 1KHzFlame resistant polyamide housing with reinforced isolation and cable clampFurniture integration and mounting on material with normal flammability allowedDimension : 22 x 32 x 345 mm (l x w x h)Connection: screw terminal Supply voltage: AC 230 – 240V 50 /60 Hz & DC 176 – 276 Load capacity at -20…45°C ambient temperature Stand-by power: < 0,4W Total harmonic distortion (THD) < 5%Efficiency > 92%Cable length secondary side: max. 10m Type of protection: IP 20 Protection type: II Suitable for luminaires of protection class I and IIEMC fulfilled according EN61547Manufacturing standard EN 61347-1; EN61347-2-13Long life 50.000 at tc=85 °COrdering referenceOTi DALI 80/220-240/24 1-4 chEAN 4052899452893
Products
| Product |
|
|
|
|
|
Data sheet | ||
|---|---|---|---|---|---|---|---|---|
|
OTi DALI 50/220…240/24 1…4 CH
|
50 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
|
OTi DALI 50/220…240/24 TW
|
50 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
|
|
OTi DALI 80/220…240/24 1…4 CH
|
80 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
|
OTi DALI 80/220…240/24 TW
|
80 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
|
OTi DALI 160/220…240/24 1-2 CH
|
160 W | Yes | 300.0 mm | 50.0 mm | 35.0 mm | ||
|
OTi DALI 160/220…240/24 TW
|
160 W | Yes | 300.0 mm | 50.0 mm | 35.0 mm | ||
|
OTi DALI 50/220-240/24 4CHDT6/8
|
50 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
|
OTi DALI 80/220-240/24 4CHDT6/8
|
80 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
|
OTi DALI 160/220-240/24 4CHDT6/8
|
160 W | Yes | 300.0 mm | 50.0 mm | 35.0 mm | ||
|
OTi DALI 50/220-240/24 1CH
|
50 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
|
OTi DALI 80/220-240/24 1CH
|
80 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
|
OTi DALI 160/220-240/24 1CH
|
160 W | Yes | 300.0 mm | 50.0 mm | 35.0 mm |
