OTi DALI 50/220-240/24 1CH
- Intelligent power matching thanks to Smart power supply
- Form factor for mounting on the cove or in luminaires
- No stroboscopic effect thanks to patented high PWM frequency management (> 2 kHz)
- Suitable for installation in emergency lighting systems according to EN 60598-2-22
- DALI message detection "LED Module failure"
- IP rating: IP20
- Cove lighting, wall washer, corridor, handrail, luminous ceilings
- Suitable for use in luminaires of protection class I and II
- Suitable for 24 V LED modules
Technical Data
Electrical data
Nominal input voltage
220 240 V
Mains frequency
50/60 Hz
Input voltage AC
198 264 V
Total harmonic distortion
< 5 %
Power factor λ
0.82C 0.99
Efficiency in full-load
92 %
Device power loss
4.4 W
Networked standby power
<0.50 W
Inrush current
41 A
Max. ECG no. on circuit breaker 10 A (B)
13
Max. ECG no. on circuit breaker 10 A (C)
22
Max. ECG no. on circuit breaker 16 A (C)
36
Max. ECG no. on circuit breaker 16 A (B)
21
Max. ECG no. on circuit breaker 25 A (B)
33
Surge capability (L-N)
1 kV
Nominal output voltage
24 V
U-OUT (working voltage)
24.2 V
Nominal output power
50 W
Maximum output power
50 W
Galvanic isolation
SELV
Galvanic isolation primary/secondary
3.75 kV
Output ripple Voltage (100 Hz)
< 1 %
Output PWM frequency
> 2000 Hz
Input voltage DC
176 276 V
Dimensions & weight
Mounting hole spacing, length
300.6 mm
Product weight
191.00 g
Cable cross-section, input side
0.5 2.5 mm²
Cable cross-section, output side
0.2 1.5 mm²
Wire preparation length, input side
6.0 mm
Wire preparation length, output side
5.0 mm
Width
32.0 mm
Height
22.0 mm
Length
346.0 mm
Colors & materials
Casing material
Plastic
Temperatures & operating conditions
Ambient temperature range
-20 +45 °C
Maximum temperature at tc test point
70 °C
Max.housing temperature in case of fault
115 °C
Temperature range at storage
-40 +85 °C
Permitted rel. humidity during operation
5 85 %
Lifespan
ECG lifetime
50000 h
Capabilities
Dimmable
Yes
Dimming interface
DALI-2 / Touch DIM
Dimming range
0.1 100 %
Dimming method
Pulse Width Modulation
Overheating protection
Automatic reversible
Overload protection
Automatic reversible
Short-circuit protection
Automatic reversible
No-load proof
Yes
Intended for no-load operation
No
Suitable for fixtures with prot. class
I / II
Type of connection, input side
Screw terminal
Type of connection, output side
Screw terminal
Control interface
DALI-2
Number of channels
1
Programming
Tuner4TRONIC
Yes
Certificates & standards
Approval marks approval
BIS / CCC / CE / EAC / EL / ENEC 10 / RCM / VDE / VDE-ENEC
Standards
Acc. to EN 61347-1/Acc. to EN 61347-2-13/Acc. to EN 61547/Acc. to EN 61000-3-2/Acc. to EN 62384/Acc. to EN 60598-2-22/Acc. to EN 62386/Acc. to EN 55015
Protection class
II
Logistical data
Commodity code
85044083900
Environmental information
Information according Art. 33 of EU Regulation (EC) 1907/2006 (REACh)
Date of Declaration
11-09-2023
Primary Article Identifier
4062172177962
Candidate List Substance 1
Lead
CAS No. of substance 1
7439-92-1
Safe Use Instruction
The identification of the Candidate List substance is sufficient to allow safe use of the article.
Declaration No. in SCIP database
81daf030-1143-4c24-ad49-3416b3025617
Packaging information
EAN |
Unit |
Piece |
Dimension l x w x h |
Weight |
Volume |
---|---|---|---|---|---|
4062172177962 |
UNV
| 1 | |||
4062172177979 |
VS
| 20 | 370mm x 170mm x 113mm | 3998.00g | 7.11dm³ |
Downloads
Data sheets
Information about Family
This driver is suitable for emergency lighting systems. The output on the multi-channel versions can be shared arbitrarily among the 2 or 4 channels and the PWM frequency > 2kHz minimizes stroboscopic effects.
- Dimmable via Touch DIM
- Available as single-channel or multi-channel with DT6 and DT8 in one device
- Dimming range: 0.1 100 % (for 50-80-160W) or 1 100 % (for 30W)
- Line frequency: 0 Hz | 50 Hz | 60 Hz
Intended for use with LED modules.
The forward voltage of the LED light source shall be within the defined operating window of the control gear in all operating conditions including dimming if applicable.
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.
Products
Product |
|
|
|
|
|
Data sheet | ||
---|---|---|---|---|---|---|---|---|
![]() |
OTi DALI 30/220-240/24 1CH
|
30 W | Yes | 103.0 mm | 67.0 mm | 29.5 mm | ||
![]() |
OTi DALI 50/220-240/24 1CH G3
|
50 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
![]() |
OTi DALI 80/220-240/24 1CH G3
|
80 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
![]() |
OTi DALI 160/220-240/24 1CH G3
|
160 W | Yes | 300.0 mm | 50.0 mm | 35.0 mm | ||
![]() |
OTi DALI 50/220-240/ 24 4CH DT6/8 G3
|
50 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
![]() |
OTi DALI 80/220-240/ 24 4CH DT6/8 G3
|
80 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
![]() |
OTi DALI 160/220-240/ 24 2CH DT6/8 G3
|
160 W | Yes | 300.0 mm | 50.0 mm | 35.0 mm | ||
![]() |
OTi DALI 50/220-240/24 1CH
|
50 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
![]() |
OTi DALI 80/220-240/24 1CH
|
80 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
![]() |
OTi DALI 160/220-240/24 1CH
|
160 W | Yes | 300.0 mm | 50.0 mm | 35.0 mm | ||
![]() |
OTi DALI 50/220-240/24 4CHDT6/8
|
50 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
![]() |
OTi DALI 80/220-240/24 4CHDT6/8
|
80 W | Yes | 346.0 mm | 32.0 mm | 22.0 mm | ||
![]() |
OTi DALI 160/220-240/24 2CHDT6/8
|
160 W | Yes | 300.0 mm | 50.0 mm | 35.0 mm |